The setting tool used with the HDI-P is designed to leave a mark on the lip of the anchor to allow an inspector to determine that the HDI-P has been set properly. The HDI-P has a lip that allows for flush installation and ensures consistent anchor depth. The shallow embedment requirement cuts down drilling time for fast installation. HDI-P Short Drop-in Anchor – specifically designed for use in hollow core panel, precast and post tension concrete applications where maximum embedment requirements equal 3/4”.
The use of a setting tool is required for each of the five diameters of HDI concrete anchors.
Has hilti anchors how to#
You might be interested: Quick Answer: How To Clean An Epoxy Garage Floor? How do adhesive anchors work?Īdhesive anchor is a post-installed anchor that is inserted into a drilled hole in hardened concrete, masonry or stone. The area receiving the material should never be less than 2” deep and 2” wide. Diameter of hole should be 3 to 4 times the diameter of the fixture being placed and the depth of the hole must be 8 to 12 times the fixtures diameter. How deep should anchor bolts be in concrete?Įnsure the area is wide and deep enough to provide proper support. The embedded depth for headed anchor bolts is determined by measuring the surface of the masonry to the bolt head bearing surface. When anchoring to masonry, the general rule is that the embedded depth should be at least four bolt diameters or 2 inches (51 mm) deep, whichever is greater. 11 How much weight can a 3/8 concrete anchor hold?.10 Can you put anchor bolts in wet concrete?.
6 What is the strongest concrete anchor?.2 How deep should anchor bolts be in concrete?.